Live Trucks. Live Drivers. Live Status.
Loadara is built to read your existing telematics feed and turn raw GPS into dispatch-ready status.
Your ELD data, finally where dispatch and maintenance can use it.
Status Derived From Location
Geofences at the pit, site, and yard set driver status.
HOS & Safety in Dispatch
HOS and safety scores where you assign the job.
Fault Codes Where You Work
DM1 and DM2 codes land in the maintenance inbox.
Where every truck is, right now.
Every active truck on one map with location, derived status, safety score, MPG, and engine codes.
Live location at the polling rate
Derived states from rolling out to returning
Geofence event log per truck
30-day MPG, safety, and engine-hours trend
Jump from the board to telemetry
No buttons. No driver taps. No status drift.
Once your feed connects, geofence enter and exit events derive status with no driver taps.
Pit, jobsite, and yard geofences per project
Enter and exit events derive each state
Status reconciles against the ticket flow
Manual override with reason logged
Your existing geofence library carries over
Compliance data in the workflow, not in a separate tab.
HOS drives assignment eligibility, safety scores sit in the roster, and fault codes route to maintenance.
HOS remaining next to every driver
Safety score and trend on the roster
Fault codes queued with a severity tag
Idle, hard brake, speeding in scorecards
Roadmap: Samsara, Motive, Geotab (2026)
Where telematics signal lands across Loadara.
Run your next load on Loadara.
Set up your operation in an afternoon - no rollout project, no lock-in.
No credit card required · 14-day free trial · Cancel any time